Side loading float gage
The liquid level of magnetic float is composed of the dry reed pipe, precise resistance and single chip circuit. When magnetic float lines of magnetic force effect to the level a certain position, the dry reed pipe in the position of the closure, magnetic float with liquid surface (interface) level changes, the SCM will transform processing circuit liquid (world) the change of the surface height is converted into linear 4 ~ 20 mADC signal output and relay contact output, realize the liquid (community) level position signal detection, transmission and alarm control.
The magnetic liquid level sensor (meter) USES the imported high quality sensor and signal conversion device, which has excellent long-term stability and reliability.
Simple, stable, reliable and repeatable;
It is not affected by the physical and chemical states of the dielectric. The effect of conductivity, dielectric constant, foam, pressure, temperature, evaporation, boiling, bubble.
The use of different materials can be used for various kinds of strong and weak corrosive, inflammable and explosive, toxic, highly radioactive, and dirty medium environment.
Surface measurement of liquid level or two different density media;
Explosion-proof structure design, suitable for explosive environment.
The secondary system 4-20ma current output, can be carried with 0.56 "LED digital display, for the night long distance observation.
Measuring range: 200 ~ 6000mm (greater than 6m special orders)
Resolution: 10mm (commonly used), 5mm, 20mm choice
4-20 ma output signals: (two wire) linear resistance, 200 Ω/m (1/2 ", 3/8 "thread installation)
24 VDC power supply and the load resistance: 500 Ω (without indicating meter)
Transmit distance: > 1000m
Working power: 16-30vdc
Media density: 0.5 g/cm3 (< 0.5 g/cm3 special order)
Nominal pressure: PN2.5 ~ PN160 (x 0.1 MPa) (special accessible PN320)
Working temperature: - 40 ~ 80 ℃, 120 ℃, 150 ℃ or less or less fragmentation
Float diameter: 24 ~ Φ Φ 120 as defined by the pressure, density (producers)
Installation flange: DN40 ~ DN150 / RF/PL (HG/t20592-2009) (can also be produced according to user's requirement)
2 "screw (down)
1/2 "thread" (upward install, resistance signal output)
3/8 "screw" (upward install, resistance signal output)
Installation does not verticality: + 25 ℃ or less
Electrical interface: M20 x 1.5 threads (other interfaces should be noted)
Three-wire shield cable
Protection level: IP65
Explosion level: ExiaII CT6Ga, ExdII CT6Gb
Ball float liquid level gauge is widely used in petroleum, chemical, oil, medicine, food, and other industries of all kinds of storage tank, storage tank, liquid in the liquid pool, reaction pot, fermentation tank, oil, weak acid and alkali solution, such as high and low pressure container, with 304, 316 l, 1 cr18ni9ti, 304 + 0 cr18n - i9, PTFE, 00 cr17ni14mo2, PP material such as compatible medium liquid level measurement, two kinds of different medium interface, transmit and display.