Electric tracing of heat magnetic flip plate liquid level

• 

Electric heat tracing magnetic flap liquid level meter, electric heating magnetic flap liquid level …

Electric heat tracing magnetic flap liquid level meter, electric heating magnetic flap liquid level meter is outside the body of the electrical installation in the base type mixing heat source, asbestos insulation layer, can keep the temperature of the liquid in the main body so that it can make the liquid flow normally around 75 ℃, the lateral made from 304 stainless steel plate appearance. The liquid level of a magnetic flip plate is suitable for the liquid that solidifies the liquid at low temperature.

The main parameters of the liquid level of the magnetic flip plate

Measuring range: 500 ~ 8000mm

Accuracy: plus or minus 10mm (insulation)

Job stress: less than 2.5 MPa (common type)

Less than or equal to 10.0 MPa (high pressure type)

Less than 2.5 MPa

To 40 ℃ to 50 ℃ ambient temperature

The liquid level density of the liquid level of the magnetic flip plate: 0.45 ~ 2g/cm3

Density difference: greater than 0.15 g/cm3 (measurement boundary)

Low medium temperature: 80 ℃ ~ + 450 ℃

Power: 25 w/m, 35 w/m to maintain highest temperature: 65 ℃

The viscosity of the medium: less than 0.4 Pa. S, which can be easily crystallized when the medium or temperature is low, which can be used according to the user's requirement.

The ambient vibration: the frequency is less than 25HZ, the amplitude is less than 0.5 mm

Interface flange: adopted by the ministry of chemical engineering in 1997, the standard of HG20592 ~ 20635-97.

If users need to adopt other standards (such as GB, ANSI, DIN, etc.), they can be designed according to the user's needs.